MX-Fv

Tool especially designed for tensioning wire with the whole range of MAXTENSOR® joiners and tensioners.

Manufactured in polymer and steel core

For moderate use

Tensioning of wire
  • Easy to install: up to 70% faster than traditional joining systems.
  • The tension on the wire is produced by tensioning using the MAXTENSOR® tool.
  • Leave a minimum length of 10 cm from the free end of the wire to the outlet hole of the tensioner (see image).
Weight Load limit
 0,85 Kg
(1.4 lb)
 150 Kg
(330 lb)

MAXTENSOR® MX-FV is made of polymer reinforced with fibre glass and a steel core, for tensioning wire across the whole range of MAXTENSOR® joiners and tensioners. It is perfect for anything that requires moderate use and good value for money.

When planning the installation with Maxtensor® connectors and tensioners, you must take into account the following tips for use.

  • The range of connectors and wire tensioners are usable with many of the wires for agricultural use on trellises, fences, or support wires. Given the variety of types of wire existing in the market, it is recommended to consult the technical department of Maxtensor Internacional S.L. on which would be the most suitable product depending on the application and the type of wire used.
  • Do not use the product outside the recommended range of diameters.
  • Do not exceed the load limit of any product.
  • The indicated load limit is a static load value, and depends on the type of wire and diameter used. If you think that the product will be subject to high loads, use wire diameters close to the maximum value of the range indicated on the product. In case of doubt, it is recommended to consult the technical department of Maxtensor Internacional S.L. on which would be the most suitable product depending on the application and the type of wire used.
  • It should be taken into account that the dynamic loads produced by the wind, impacts, vibrations, can significantly increase the service loads on the wire affecting the operation of the product.
  • It should be taken into account that dirt, chemicals and insects, among others inside the product, can jeopardize the proper functioning of the device.
  • Leave a minimum length of 10 cm from the free end of the wire to the outlet hole of the product.
  • Secure free ends of excess wire.
  • Check the installation status regularly.
MAXTENSOR® catalogue Farm and livestock line (EN) – pdf 2,5 MB
MAXTENSOR® catalogue Agricultura y ganadería (ES) – pdf 2,6 MB
MAXTENSOR® catalogue Gamme agriculture et élevage (FR) – pdf 2,5 MB
Related products
mx1-WP

Line end tensioner for wire from 1.8 to 3.2 mm in diameter.

Maximum load 400 kg (880 lb).

Includes protrusion to protect the wire from being cut by the pole.

SEE FACT SHEET

mx2

Joiner and tensioner for wire from 1.8 to 3.2 mm in diameter.

Maximum load 400 kg (880 lb)

SEE FACT SHEET

MX-Ac

Tensioning tool made of cast steel.

For intensive use.

Recommended maximum load 350 kg

SEE FACT SHEET